Camera Web Server ESP32

General
1

Hello everyone,
Am I the only one getting this error while trying to use the camera ?

13:45:09.941 -> ets Jul 29 2019 12:21:46

13:45:09.941 ->

13:45:09.941 -> rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)

13:45:09.941 -> configsip: 0, SPIWP:0xee

13:45:09.941 -> clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00

13:45:09.941 -> mode:DIO, clock div:1

13:45:09.941 -> load:0x3fff0030,len:4832

13:45:09.941 -> load:0x40078000,len:16460

13:45:09.941 -> load:0x40080400,len:4

13:45:09.941 -> load:0x40080404,len:3504

13:45:09.941 -> entry 0x400805cc

13:45:10.470 -> E (544) esp_core�fVW }���͡� No core dump partition found!

13:45:10.470 -> E (544) esp_core_dump_flash: No core dump partition found!

13:45:10.470 -> E (363) quad_psram: PSRAM ID read error: 0xffffffff, PSRAM chip not found or not supported

13:45:10.517 ->

13:45:11.295 -> .

13:45:11.295 -> WiFi connected

13:45:11.341 -> Camera Ready! Use 'http://192.168.2.196' to connect
2

the esp32 was not fully plug to the camera extension.

3

Has your issue has been resolved? Could it be that the module wasn’t fully inserted?

4

Hello, yes my issue is resolved. I saw a lot of people with the same error online but in my case it was that. The esp32 was not plug all the way down.

Thank you.